Elektralite CP100xt Manual Part Two Manual do Utilizador descarregar pdf (Página 13)

STORING A CUE

1) Move the lights into position & adjust their features to make a pretty look. You can also use

your Presets and Feature Presets to do this for you.

2) Press STORE-CUE-n-ENTER to save the Cue

3) Press CUE-ENTER to see the Cue Editor display

CUE EDITOR: Cue number: 1

Preset (1): 7 Name: _

Fix Filt (0): 0

In time: 2.5

Dim Filt (0): 0

Out time: 2.3

4) Move the cursor to the respective positions to change the fade In Time, Out Time, Name, etc.

5) Press STORE-CUE-ENTER to save the Cue with it’s new information.

6) Press CUE-n-GO to see the Cue happen.

STORING A CHASE

1) Press CHASE-ENTER to bring up the Chase Editor display.

CHASE EDITOR: Chase number: 10

Step rate: 1

20 Name: _

Xfade %: 5

0 Step (8): 1

Mode: forward Cue (1): 55

2) Move the cursor to the “Cue” field.

3) Press CHASE-RECORD to turn on the “Record” LED

NOTE:

the “Record” button is located on the right side of the board above the “Grand Master

”

fader.

4) Press CUE-n-ENTER

5) The “Step” in the chase editor should increment by one. If it doesn’t, make sure that the

“SOLO” button LED is lit.

NOTE:

general rule of thumb...just keep this button on at all times and make sure it stays on! We’ll

get into it later.

6) Repeat step 4 until all the Cues that you want are in the Chase.

7) Press the “Record” button to turn the LED off.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 108 109

Sem comentários

Elektralite CP100xt Manual Part Two Manual do Utilizador Página 13